The short version of anti-doping category fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-02-04 and is reviewed periodically as new material appears.
Standard practice for the solid form is storage at minus twenty degrees Celsius or colder, kept dry and away from light. Containers are usually sealed with a desiccant to limit moisture uptake. Reconstituted solutions are typically held at two to eight degrees Celsius and used within a short window, because potency can decline over days to weeks depending on the buffer and concentration. Freezing an already dissolved sample may help, though repeated thawing is discouraged. Specific shelf-life claims vary between suppliers and are rarely supported by published stability studies.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometers, a wavelength that captures the peptide backbone. The main peak area is reported as a percentage of total peak area, which serves as a conventional purity figure. Mass spectrometry provides an independent check on molecular mass and helps confirm the expected sequence. Additional tests may include amino acid analysis and water content determination. Results are only comparable when the same column, gradient, and detection settings are used.
Peptides are susceptible to hydrolysis, oxidation, and aggregation, and BPC-157 is no exception. The lyophilized powder form is generally more stable than a solution because residual moisture is low and molecular mobility is reduced. Once dissolved, the peptide is exposed to water, oxygen, and trace metal ions that accelerate degradation. Light exposure and repeated freeze-thaw cycles are also commonly cited as sources of loss. These general principles guide most handling recommendations found in supplier documentation.
BPC-157 is a synthetic peptide composed of fifteen amino acid residues, with the sequence Gly-Glu-Pro-Pro-Pro-Gly-Lys-Pro-Ala-Asp-Asp-Ala-Gly-Leu-Val. Its name derives from body protection compound, a term used for a protein fraction identified in human gastric juice. Researchers in Zagreb first reported the pentadecapeptide in the early 1990s and described it as a stable fragment of that larger protein. The compound is also catalogued as PL 14736 and, in some commercial contexts, as bepecin. Its molecular formula is C62H98N16O22 and its monoisotopic mass is approximately 1419 daltons.
Most published work on BPC-157 consists of preclinical studies, including rodent models of tissue injury, gastrointestinal lesions, and vascular or tendon damage, together with in vitro cell assays. Reviews frequently note that the mechanisms proposed in these papers remain incompletely characterised and that findings have not been confirmed in large randomised human trials. The compound is widely sold as a research chemical rather than a licensed medicine, and labels commonly carry a statement that it is not for human use. Whether any of the reported animal effects translate to humans is an open question rather than an established result.
Terminology in the literature is not fully standardised. Papers and product listings use BPC-157, BPC 157, and the longer phrase stable gastric pentadecapeptide BPC 157 interchangeably, and synonyms such as bepecin or PL 14736 appear in older or company-linked publications. Purity claims and reported masses can also differ between sources because peptide preparations may include counterions, residual solvents, or bound water. This variability complicates direct comparison of results across studies and makes the exact identity and grade of a given sample worth verifying. Discussions of the compound should therefore specify the source, salt form, and stated purity where those are known.
| Property | Value | Notes |
|---|---|---|
| Lyophilized powder storage | -20 C or colder, desiccated, protected from light | Long-term condition cited in supplier documentation |
| Reconstituted solution storage | 2-8 C for short-term use | Stability decreases after dissolution |
| Appearance | White to off-white lyophilized powder | Used as a visual identity check |
| Solubility | Soluble in water and aqueous buffers | Limited solubility in nonpolar organic solvents |
| Typical analytical method | Reversed-phase HPLC with UV detection at 214 nm | Purity estimate; mass spectrometry confirms molecular mass |
The main chemical liabilities of this sequence are peptide-bond hydrolysis and possible aspartate-related reactions, since the peptide contains aspartic acid residues but no cysteine, methionine, or tryptophan. Absence of those three residues removes the most common oxidation and disulfide pathways from consideration. Studies of related peptides indicate that aspartate isomerisation and aspartimide formation occur most readily at Asp-Gly and Asp-Ala positions, and open questions remain about how quickly those reactions proceed under ordinary laboratory conditions. Storage guidance typically emphasises cool, dry, dark conditions to slow hydrolysis.
Identity and purity are usually assessed with reversed-phase high-performance liquid chromatography, often paired with mass spectrometry using electrospray or MALDI ionisation. Amino acid analysis and peptide mapping by enzymatic digestion provide additional sequence-level confirmation. Purity is commonly reported as an area percentage from a chromatographic trace, and water content can be measured by Karl Fischer titration. Reported masses may differ by tens of daltons between sources because preparations can contain acetate or trifluoroacetate counterions, and such differences are not by themselves evidence of a different peptide.
BPC-157 is normally distributed as a lyophilised powder that ranges from white to off-white in appearance. The peptide dissolves readily in water, normal saline, and common aqueous buffers, and it is poorly soluble in nonpolar solvents such as hexane or vegetable oils. Lyophilised vials take up moisture if left open, which changes the mass of powder in the container and complicates any later weighing. Because the material is handled in small quantities, static and adhesion to glass or plastic can also cause noticeable losses during transfer.
Outside laboratory supply channels, the peptide is sold as a research chemical, a category that carries no requirement to demonstrate purity, identity, or freedom from contamination. Because it is not an approved medicine, products labeled BPC-157 sit in a regulatory gap in many countries, and actual content may differ from the label. Sports organizations list it among prohibited substances, so its presence in an athlete's sample can produce a doping finding regardless of how the material was obtained.
BPC-157 is a synthetic peptide of fifteen amino acids, written as GEPPPGKPADDAGLV, whose sequence matches part of a larger protein identified in human gastric juice. That parent protein was described in stomach-secretion research, and the fifteen-residue fragment was named body protection compound, which gives the peptide its common label. Material used in experiments is produced by solid-phase peptide synthesis rather than extracted from tissue. The reported molecular weight is about 1419 daltons, and the chain contains several proline residues, a feature that appears in discussions of its resistance to enzymatic breakdown.
Most published findings come from rodent models, where the peptide has been examined in wound-healing, gastrointestinal-lesion, tendon, and vascular-injury preparations. A smaller number of early human studies have been reported, chiefly in inflammatory bowel conditions, but the public record is short and has not led to marketing approval in the United States or the European Union. Reviewers therefore classify the compound as investigational, and whether animal results carry over to people remains an open question rather than a settled one.
Quality assessment rests on two separate questions: whether the chain is the intended one, and how much of the sample is that chain. Reverse-phase high-performance liquid chromatography with ultraviolet detection is the standard purity measurement, while mass spectrometry confirms identity through the observed molecular mass. Amino acid analysis and sequence verification provide further checks. A reported purity percentage describes the proportion of the sample represented by the main peak, not the amount of peptide by mass, since counter-ions and water make up part of any lyophilized lot.
In its usual supplied form, the peptide is a white to off-white lyophilized powder that dissolves readily in water and in aqueous buffers. Powder keeps far longer than solution, so material is normally shipped and stored dry, then dissolved only when needed. Once in solution, the chain is subject to hydrolysis and the liquid supports microbial growth, and practical guidance generally treats the dissolved form as short-lived. Containers should stay sealed and desiccated, because the powder takes up moisture from air.
== Chemistry == SR-17018 is variously described as a piperidinylbenzimidazolone, piperidine–benzimidazole, or N-benzyl piperidine 4-benzimidazolone derivative. It is structurally related to designer opioids such as brorphine.
== External links == Clinical trial number NCT02399085 for "A Study to Evaluate the Safety and Efficacy of Lenalidomide With MOR00208 in Patients With R-R DLBCL (L-MIND)" at ClinicalTrials.gov Clinical trial number NCT04680052 for "A Phase 3 Study to Assess Efficacy and Safety of Tafasitamab Plus Lenalidomide and Rituximab Compared to Placebo Plus Lenalidomide and Rituximab in Patients With Relapsed/Refractory (R/R) Follicular Lymphoma or Marginal Zone Lymphoma. (InMIND)" at ClinicalTrials.gov
"Chamber acid" and "tower acid" were the two concentrations of sulfuric acid produced by the lead chamber process, chamber acid being the acid produced in the lead chamber itself (<70% to avoid contamination with nitrosylsulfuric acid) and tower acid being the acid recovered from the bottom of the Glover tower. They are no longer used in commercial applications, although they may be prepared in the laboratory from concentrated sulfuric acid if needed. In particular, "10 M" sulfuric acid (the modern equivalent of chamber acid, used in many titrations) is prepared by slowly adding 98% sulfuric acid to an equal volume of water, with good stirring: the temperature of the mixture can rise to 80 °C (176 °F) or higher.
Sources: en.wikipedia.org
=== Analogues === Retigabine is a bioisostere of flupirtine in which the pyridine ring has been replaced with a phenyl ring. Azetukalner (encukalner), pynegabine, and fluoxakalner are also analogues of flupirtine and retigabine.
In the first moment after an enzyme is mixed with substrate, no product has been formed and no intermediates exist. The study of the next few milliseconds of the reaction is called pre-steady-state kinetics. Pre-steady-state kinetics is therefore concerned with the formation and consumption of enzyme–substrate intermediates (such as ES or E*) until their steady-state concentrations are reached. This approach was first applied to the hydrolysis reaction catalysed by chymotrypsin. Often, the detection of an intermediate is a vital piece of evidence in investigations of what mechanism an enzyme follows. For example, in the ping–pong mechanisms that are shown above, rapid kinetic measurements can follow the release of product P and measure the formation of the modified enzyme intermediate E*. In the case of chymotrypsin, this intermediate is formed by an attack on the substrate by the nucleophilic serine in the active site and the formation of the acyl-enzyme intermediate. In the figure, the enzyme produces E* rapidly in the first few seconds of the reaction. The rate then slows as steady state is reached. This rapid burst phase of the reaction measures a single turnover of the enzyme. Consequently, the amount of product released in this burst, shown as the intercept on the y-axis of the graph, also gives the amount of functional enzyme which is present in the assay.
The TWG's criteria were used to arbitrate later element discovery claims from LBNL and JINR, as well as from research institutes in Germany (GSI) and Japan (Riken). Currently, consideration of discovery claims is performed by a IUPAC/IUPAP Joint Working Party. After priority was assigned, the elements were officially added to the periodic table, and the discoverers were invited to propose their names. By 2016, this had occurred for all elements up to 118, therefore completing the periodic table's first seven rows. The discoveries of elements beyond 106 were made possible by techniques devised by Yuri Oganessian at the JINR: cold fusion (bombardment of lead and bismuth by heavy ions) made possible the 1981–2004 discoveries of elements 107 through 112 at GSI and 113 at Riken, and he led the JINR team (in collaboration with American scientists) to discover elements 114 through 118 using hot fusion (bombardment of actinides by calcium ions) in 1998–2010. The heaviest known element, oganesson (118), is named in Oganessian's honour. Element 114 is named flerovium in honour of his predecessor and mentor Flyorov. In celebration of the periodic table's 150th anniversary, the United Nations declared the year 2019 as the International Year of the Periodic Table, celebrating "one of the most significant achievements in science". The discovery criteria set down by the TWG were updated in 2020 in response to experimental and theoretical progress that had not been foreseen in 1991. Today, the periodic table is among the most recognisable icons of chemistry.
==== Lucid dreaming ==== Lucid dreaming has been found to be associated with greater mental well-being. It also was not associated with poorer sleep quality nor with cognitive dissociation. There is also some evidence lucid dreaming therapy can help with nightmare reduction.
Sources: en.wikipedia.org
Reversed-phase HPLC separates the sample into peaks, and the main peak is expressed as a percentage of total peak area. Mass spectrometry is then used to confirm that the molecular mass matches the expected value.
Low temperature and low moisture slow hydrolysis and oxidation, the two main degradation routes for short peptides. A desiccant limits water uptake each time the vial is opened.
No single number captures identity, counter-ion content, water content, or sterility. A purity figure from one laboratory method reflects only what that method detects, and different methods can give different values for the same sample.
BPC-157 is a synthetic fifteen-amino-acid peptide whose sequence corresponds to a fragment of a protein found in human gastric juice. It is studied mainly in preclinical research and is not an approved pharmaceutical product in major markets. Materials sold for laboratory use are typically labelled as research chemicals.